Quote Originally Posted by ZCommander View Post
Great I'm finally getting a grip on this mobo!

Currently I'm testing the CPU for overclocking, when finished I'll overclock the RAM, any way :

Mobo: R2E
CPU: 920 batch 3841A534
RAM : OCZ 3x2 GB intel extreme edition 1600MHz 8-8-8-24
Cooler : Cooler master V8 ( switching to water cooling in the very near future)

CPU @ 3.6 currently
RAM @ 1200 ( will try higher when completeing CPU testing)

CPU 1.25
CPU PLL Auto
QPI/DRAm Auto
IOH Auto
IOH PCIE Auto
ICH 1.1 Auto
ICH PCIE Auto
DRAM 1.65

I've finished 10 Passes of intel stress test, 7 hours of OCCT and now I've juststarted prime95, will try it for 24 hours.
Strange behavior , I finished 20 hours of prime 95 with the above settings with no errors and decided to run the RAM at 1600 8-8-824 T1 ( this is the RAM default speed).
I restarted the computer changed Dram voltage into 1.65 and applied the RAM settings as needed.
Logged into windows ran Everest and Asus probe just to compare between it, started OCCT for fast evaluation for 4 hours.
After the 4 hours I came back to check the PC, found out that on everest and asus probe the voltages are all missed up with some strange readings!!!
OCCT finished with no errors, I decided to log into the BIOS and investigate and also apply manual voltage settings to the rest of the Auto values, as soon as I restarted windows the PC kept on running the Asus LCD didn’t display the normal boot sequence and the PC didn’t display any thing on the monitor.
I cold boot it and it refused to come up at all, I’ve witnessed the same problem I’ve seen with the my old EX58-extreme which can be seen in this clip.http://www.youtube.com/watch?v=mdolaz3I_xE

Any way, I powered the PSU off then on, the mobo booted fine but with an error message that states that my overclocking is not correct, I logged into the BIOS to find out that all voltages are missed up pretty bad!!!!!
Every thing is not what I stated there, like CPU voltage is at 1.55+.
I loaded the profile I saved, switched all voltage values to auto except the CPU voltage and RAM voltage and now I’m using Prime95 to test it again!!