Hello All,

I posted a few days ago but didn't get a respose.

Here is my system:
BIOS: F9
GA-EP45-UD3P rev 1.0

E8500 E0 Stepping @ 4.105GHz 1.40625v
PC2-8800 RAM 5-5-5-15 @ 1159MHz

I am trying to optimize my O/C, but if I try to lower my vCore I get a BSOD. Below is my Template:

I idle around 35degC with an internal case temp of 24degC.

The peak I have seen is ~71ish degC during Intel BurnIn test (linpack) and only about ~64-65degC with Prime95 Small FFT.


Can you help me to get a cooler running chip?

Thanks,
-Jsunn

Code:
Robust Graphics Booster.........................[ Auto     ]
CPU Clock Ratio.................................[ 8  x     ]
Fine CPU Clock Ratio............................[ + .5     ]
CPU Frequency 4.105GHz..........................[ 483x 8.5 ]
 
******Clock Chip Control******
 
CPU Host Clock Control..........................[ Enabled  ]
CPU Host Frequency (Mhz)........................[ 483      ]
PCI Express Frequency (Mhz).....................[ 100      ]
C.I.A 2 [Disabled] 
 
 
******Advanced Clock Control******

CPU Clock Drive.........................[800mV]
PCI Express Clock Drive.................[900mV]
CPU Clock Skew..........................[400ps]
MCH Clock Skew..........................[300ps]

******DRAM Performance Control******
 
Performance Enhance.............................[ Standard ]
MCH Frequency Latch.............................[ 333     ]
System Memory Multipler.........................[ 2.40B   ]
Memory Frequency 1066...........................[ 1159    ]
DRAM Timing Selectable..........................[ Manual  ]
 
CAS Latency Time................................[ 5       ]
tRCD............................................[ 5       ]
tRP.............................................[ 5       ]
tRAS............................................[ 15      ]
 
******Motherboard Voltage Control******
 
Load-Line Calibration...........................[ Enabled ]
CPU Vcore         [ 1.25 ]......................[ 1.40625v]
CPU Termination   [ 1.20    ]...................[ 1.40v   ]
CPU PLL           [ 1.50    ]...................[ 1.610v  ]
CPU Reference     [ 0.760   ]...................[ .956v   ]
 
MCH Core          [ 1.100   ]...................[ 1.360v  ]
MCH Reference     [ 0.760   ]...................[ 0.866v  ]
MCH/DRAM Reference [ 0.900   ]..................[ 1.11v   ]
ICH I/O           [ 1.500   ]...................[ auto    ]
ICH Core          [ 1.100   ]...................[ auto    ]

DRAM Voltage     [ 1.800v]...................[1.900v]
DRAM Termination [0.900v]...................[auto]
Channel A Reference [0.900v]................[auto]
Channel B Reference [0.900v]................[auto]