Originally Posted by Kayso
What I see is, that all you voltages are on AUTO
You will never overclock your PC with voltages on auto.
Try this one:
Code:Ai Overclock Tuner: Manual OC From CPU Level Up: Auto Ratio CMOS Setting: 8 FSB Frequency: 533 CPU Clock Skew: Auto NB Clock Skew: Auto FSB Strap to North Bridge: 333MHz DRAM Frequency: 1066 DRAM CLK Skew on Channel A1: Auto DRAM CLK Skew on Channel A2: Auto DRAM CLK Skew on Channel B1: Auto DRAM CLK Skew on Channel B2: Auto DRAM Timing Control: Auto 1st Information: CAS# Latency: 5 DRAM Clocks DRAM RAS# to CAS# Delay: 5 DRAM Clocks DRAM RAS# Precharge: 5 DRAM Clocks DRAM RAS# Activate to Precharge: 15 DRAM Clocks RAS# to RAS# Delay: Auto Row Refresh Recycle Time: 55 DRAM Clocks Write Recovery Time: Auto Read to Precharge Time: Auto 2nd Information: Read to Write Delay (S/D): Auto Write to Read Delay (S): Auto Write to Read Delay (D): Auto Read to Read Delay (S): Auto Read to Read Delay (D): Auto Write to Write Delay (S): Auto Write to Write Delay (D): Auto 3rd Information: Write to PRE Delay: Auto Read to PRE Delay: Auto PRE to PRE Delay: Auto All PRE to ACT Delay: Auto All PRE to REF Delay: Auto DRAM Static Read Control: Enabled DRAM Read Training: Enabled MEM. OC Charger: Disabled Ai Clock Twister: Stronger Transaction Booster : Manual Common Performance Level [10] Pull-In of CHA PH1 Disabled Pull-In of CHA PH2 Disabled Pull-In of CHA PH3 Disabled Pull-In of CHA PH4 Disabled Pull-In of CHA PH5 Disabled Pull-In of CHB PH1 Disabled Pull-In of CHB PH2 Disabled Pull-In of CHB PH3 Disabled Pull-In of CHB PH4 Disabled Pull-In of CHB PH5 Disabled PCIE Frequency : 101 CPU Voltage: I don't know what vcore will need your CPU, but try with 1.4 as a start, if that doesn't work, bump three steps up CPU PLL Voltage:1.55 FSB Termination Voltage:1.325 DRAM Voltage: 2.1 North Bridge Voltage:1.4 South Bridge 1.5 Voltage: 1.55 South Bridge 1.1 Voltage: 1.15 CPU GTL Reference (0): Auto CPU GTL Reference (1): Auto CPU GTL Reference (2): Auto CPU GTL Reference (3): Auto NB GTL Reference: Auto DDR2 ChA Reference Voltage: Auto DDR2 ChB Reference Voltage: Auto North Bridge DDR Reference: Auto CPU Configuration: Ratio CMOS Setting: 8 C1E Support: Disabled Max CPUID Value Limit: Disabled Intel Virtualization Tech: Disabled CPU TM Function: Disabled Execute Disable Bit: Disabled Load-Line Calibration: Enabled CPU Spread Spectrum: Disabled PCIE Spread Spectrum: Disabled
Tried to play with these settings with NO success. Can't go further then 3.6Ghz at 9x400
Reply With Quote
Bookmarks