Doing alittle mock up today and i wanted to have the inlet and outlet on the rear of the res but its too far back and would foul the PSU. Theres a little space in the front that will just about fit my power button and the fan controller along with 2 90's into the res. The front been at such a angle should slow the water down and may even give a nice effect in the front.
What ya think?
Thanks to Olly k on the tips for soldering. I cant get on with a soldering tip so I use a little gas torch but the same way olly mentioned. Works a treat and really neat. Could do with one of those arm things with the little clips to hold the cables while im doing it, but a few lumps of bluetack (Green) does just as good a job. These cables arnt coming apart anytime soon.
Cheers.
Reply With Quote
Bookmarks