Quote Originally Posted by Snyxxx View Post
Ok, just picked up two of these boards that will be watercooled.

I use DDR-1000 4-4-4-15 OCZ VX2s and noticed that I can set the BIOS (803) to a Command Rate of 1N (I assume is 1T), but this setting does not stick in windows as confirmed by Everest and CPU-Z. It shows as 2T always.

Anyone else see this issue. I also saw it in BIOS 603 that came with the board. I was hoping BIOS 803 would fix it, but it did not.

Thanks.
I've tried that with my OCZ HPC PC2-8500 to run them at 800MHz 4-4-4-12 and 1N with the same results that you are experiencing. It always showed up 2N. I never tried to find out what's the problem.