Thanks for the link, although I am actually following this one:

http://www.maximumpc.com/article/fea...its?page=0%2C0

I have found that reading as much as possible and combing the information seems to work the best. Anyway, I have gotten back up to 200x19 on my chip and I am currently doing it with less voltage. Still stress testing, so until that's done, it isn't stable, but so far so good. One thing I did find unusual, the higher I pushed the BCLK, the lower some of my memory timings would be. For example at 160, which put my memory at 1604, my timings were auto set to 7-7-7-20-1T, at 200, timings auto set at 8-8-8-19-1T, not sure what the trc is at. Anyway, just found that odd, especially for auto and being at the same speed.