Quote Originally Posted by Thrmionicshaman View Post
The settings for GTL are floating increments based on VTT. They are not based on mV or %.They allow rather fine adjustment.
With this board there are voltage measurement points.The link [for the measurement points] I bookmarked
is dead,but it used to be on edgeofstability.
Buy/borrow/[eat and assimilate to live as a DMM] a good DMM [Fluke 179,etc] and have at it if you can find the measurement points.
Just do load/no load measurements[including 3dMark,memtest,IBT,Prime95] for Vtt and GTL,then calculate to see if they are within spec,adjust as necessary,wash-rinse-repeat and BAM-learning/living your experience Learning is Fun
Good Luck!
P.S.-Be sure not to touch other unwanted component legs when measuring the GTL chips,the legs are very close together and bridging the legs will freeze/fail test on PC.

Anyone else know where to find pics of the test points?? I don't have photobucket or whatever so I currently cannot provide my own pics but I know by heart where the points are.

***SIG Update***
E8500 Vid 1.25V Q820A966 @4.012GHz/9.5=422FSB*2.4=1013 DDR 4-4-4-10
Vcore 1.26V VMem2.316V VNB-1.37V VTT-1.12V GTL- 57-57-83 tRD 5
Everest R-9276 W-8953 C-8604 t-54.5nS SuperPi 1 Meg-11.281S
ZSamZ-anyone...How am I doing so far??? I know VMem is high but it is what works. 1:1 is tricky right now
you should be @ 500fsb memory on 333/800 divider
i'm sure you can run 1200 @ lower vdim than @ cas 4