ASUS Striker II Extreme

[neo mike]

Here Trigger try this, now im running a e8500 not a quad, so if dont work, then it is cpu settings, you havent even playe with the gtl voltages yet, and anadtech says there for quads, but anyway try this.


CPU Level Up = Auto
Memory Level Up = Auto
AI Overclock Tuner = Manual
CPU Multiplier = 8
FSB - Memory Clock Mode = Linked
FSB - Memory Ratio = Synch
FSB (QDR) MHz = 2000
MEM (DDR) MHz = 2000
LDT Frequency = 5x
PCIE Bus Slot 1 & 2 MHz = 100
PCIE Bus Slot 3 MHz = 100
SPP<->MCP Ref Clock, MHz = 201.5
SLI-Ready Memory = Disabled

Memory Timing Setting
P1 = Enabled
P2 = Enabled
tCL ( CAS Latency ) = 8
tRCD = 8
tRP = 8
tRAS = 21
Command Per Clock (CMD) = 2t
tRRD = 7
tRC = 45 to 50
tWR = 12
tWTR = auto
tFAW = auto
tRD = 10
tRTP = auto
tRFC = 110
tREF = 7.8uS

Over Voltage
CPU Voltage = 1.35v
Loadline Calibration = Enabled
CPU PLL Voltage = 1.56 1.60/()
CPU VTT voltage =1.30v 1.38
Memory Voltage = 1.94 2.00
NB Core Voltage = 1.50 1.54

SB Core Voltage = 1.50v 1.55
CPU GTL REF0 Ratio = Auto
CPU GTL REF1 Ratio = Auto
CPU GTL REF2 Ratio = Auto
CPU GTL REF3 Ratio = Auto
NB GTL REF Ratio = +30
DDR3 CHA1 Ref Volt = Auto
DDR3 CHB1 Ref Volt = Auto
DDR3 CHA2 Ref Volt = Auto
DDR3 CHB2 Ref Volt = Auto

CPU Configuration
CPU Internal Thermal Control = Enabled
Limit CPUID MaxVal = Disabled
Enhanced C1 (C1E) = Disabled
Execute Disable Bit = Enabled
Virtualization Technology = Disabled
Enhanced Intel SpeedStep(tm) Disabled
CPU Core 2 = Enabled
CPU Core 3 = Enabled
CPU Core 4 = Enabled

Spread Spectrum Control
CPU Spread Spectrum = Disabled
PCIE Spread Spectrum = Disabled
MCP PCIE Spread Spectrum = Disabled
SATA Spread Spectrum = Disabled
LDT Spread Spectrum = Disabled