My bios settings for the 2gb @4500 P95. It took many attempts trying to figure it out. It seems the most critical ones are the ref. ones. I tried to get the lowest voltages possible with vcore, mch and dram. 1:1 is alot harder I think. Also I think I got lucky with my cpu and my dimms I've had for some time and they work pretty well even with little V. I don't know why 1:1, but to me if you want to go up in a building an elavator is easier. So is 5:6. 1:1 seems like the stairs. Unless I don't know about why 1:1. (actually I don't) If you can't use the same voltages, try to use the same ratio, what I have on mine it is essential. Thanks to those in much earlier post who spoke of this.


Code:
MB Intelligent Tweaker(M.I.T.)
Robust Graphics Booster ...............: Auto 
CPU Clock Ratio .......................: 9 
CPU Frequency .........................: 4.5GHz (500X9)

Clock Chip Control 

Standard Clock Control

CPU Host Clock Control.................: [Enabled] 
CPU Host Frequency (Mhz) ..............: 500 
PCI Express Frequency (Mhz) ...........: 100 
C.I.A.2 ...............................: [Disabled] 

Advanced Clock Control

CPU Clock Drive........................: 700
PCI Express Clock Drive................: 800
CPU Clock Skew (ps)....................: 0ps 
MCH Clock Skew (ps)....................: 50ps 

DRAM Performance Control

Performance Enhance....................: Turbo
Extreme Memory Profile (X.M.P.)........: Disabled 
(G)MCH Frequency Latch.................: 333MHz 
System Memory Multiplier ..............: 2.40D 
Memory Frequency (Mhz) ................: 1200MHz

DRAM Timing Selectable ................: Manual 

Standard Timing Control

CAS Latency Time.......................: 5 
tRCD ..................................: 5 
tRP'...................................: 5 
tRAS...................................: 15 

Advanced Timing Control

Everything In Advanced Timing Control on auto. 
but tRFC 56 and Drive Strength Profiles OC-1200
DDR Write Training: Disable
Motherboard Voltage Control

CPU

Load-Line Calibration..................: [Disabled] 
CPU Vcore..............................: 1.375V
CPU Termination........................: 1.34V
CPU PLL................................: 1.63V
CPU Reference..........................: 0.888  

MCH/ICH

MCH Core...............................: 1.34V  
Reference..............................: 0.768*
MCH/DRAM Ref...........................: 0.900v
ICH I/O................................: 1.5V 
ICH Core...............................: 1.100V 

DRAM
DRAM Voltage...........................: 2.22v
DRAM Termination ......................: Auto 
Channel A Reference....................: Auto
Channel B Reference ...................: Auto