Quote Originally Posted by KingK76 View Post
Okay I am having the same issues as some of you guys in that I have gone through all the steps and am getting only 1.26v under load. I have a XFX Black Edition and started out by using conductive ink for step 1, 2b pensil for step 2 and a 500ohm VR tuned down to 150ohm for step 3. After reading all the posts I removed the conductive ink for step 1 end replaced 2, 4 and 12 with tinned wire (thin wire). Another issue is that the SMR from step 2 starts out at 1.07kohms, that seems much higher then what it should be. Given that however I was able to pencil it down to 330ohm with my 2b. And i'm still only at 1.26v under load! What am I doing wrong? Please help!!

Yup, this is EXACTLY what I'm experiencing as well. I've got the resistor down to 340 ohms......I've done the bridging on 4/5 along with the already 1/2/3/11 bridges.

I'm only getting 1.26 volts during furmark testing....

I can also confirm that I too am getting different voltages depending on what application I'm running....

During Vantage testing, I get around 1.24....during Furmark testing I get 1.26....
Wonder why its not consistent.

Any suggestions for us guy running in to the anomalies?