Quote Originally Posted by Orangeblast View Post
Well, tonight I'm going to go ahead an get this a try...

I'll show some results and stuff. If you don't hear from me, something bad happened. lol


EDIT: Okay, made the mod to just 1 of my SSC cards. 1/2/3/4/5/11 are now bridged, however to my dismay, I'm only getting around 1.228 volts...which is a bit far from the expected 1.26

I hard modded it with solder and a tiny lead...

I noticed that some people did bridging on 1/2/3/4/11/12 ...is this what I should have done? Any when I solder it, should I run solder straight across to bridge it and get rid of my tiny lead?
Okay, well I was able to get the resistor down to 340 ohms...both of my SSCs.....and I went ahead and got rid of the leads and used conductive ink..so hopefully I get the full Voltage and hopefully get a boost.

I haven't tested this new setup yet, but from last night during my first test I did see a slight boost from 735/1656/2800 to 745/1656/2850...nice boost, temps were still good as well.

Once I get my Koolance water blocks, I should be seeing some great gains.