Quote Originally Posted by coop View Post
@bobreece, I don't have same cpu as you but I ran @500 last night for 4hrs. I think xbiusx jinxed me after my last post. I was unable to get it to run past an hour or so with 1.3v mch. I had to up it to 1.34v and vcore to the settings below. After 4hrs I shut it off to try lower vcore but to no avail. Re-doing now for a longer time with the settings below. At least maybe these ref. will help get you started. Others have posted alot of info that should be helpful too that have your same cpu.



Load-Line Calibration.........................: Disabled
CPU Vcore...............1.30000V..........: 1.38125v
CPU Termination.........1.200V............: 1.320v
CPU PLL.................1.500V...............: 1.59v
CPU Reference...........0.760V............: .891v
MCH/ICH
MCH Core................1.100V.............: 1.34v
MCH Reference...........0.760V..........: .756v
MCH/DRAM Reference......900........: .890v
ICH I/O.................1.500V...............: 1.50v
ICH Core................1.100V..............: 1.10v
DRAM
DRAM Voltage............1.800V..........: 2.24 v
DRAM Termination........0.900V.......: Auto
Channel A Address Vref..0.900V.......:Auto
Channel B Address Vref..0.900V.......:Auto



[IMG][/IMG]
I think you have the same bug that i have. When you set the VTT in bios to 1.32, when you load ET6 it shows only 1.3, isn`t? And if you restart and see in bios it will be 1.3 again...

But, your settings are verry good ot 9x500, today i tested 495x8.5 but no success, i really don`t know how can i isolate the possibles issues. First i can make the cpu stable, but when i run test that involve RAM its fails within few minutes, and i`m note sure if the problem is my timmings, the voltages... i know my ram is ok, i ran memtest (with system not overclocked, everything at stock) and the memory is ok... i`m lost