Quote Originally Posted by OcAddict View Post
I've searched for the blocks, i did find the one from koolance and it's nice! But the one from bits power i didn't find. Checked there site but i did not find any watercooling parts on there Do you have a link please?

@DR3
How did you mount the pelt + wc block, do you have a pic please. I have a 60W pelt laying around here somewhere
The 80W pelter from Danger Den fits perfectly on the northbridge cooling mount once the heat sink is removed.
The screws are very small.
I used some of the mounting hardware from a Maze 4-1 pelter block I had.
But, you could probably find the hardware at the local hardware store.
The screws size I believe is 4-40 so you will need:
2 - 4-40 threaded rod (all thread)
2 - 4-40 jam nuts with lock washers
2 - 4-40 thumb nuts
2 - springs (optional)

Then you need the retaining bar.
I made this from 2 wing srews a piece of all thread and 2 thread sleeves.
2 - Wing Screws 6-32
2 - theaded sleeves
1 - small piece of all thread

Take the wing screws and drill a hole in the center of the end to accept the 4-40 all thread posts.

Do not want to go on to long about how to put it all together, pretty simple.

Here is a very poor picture of the result.