DFI Lanparty UT P45-T2RS Banter starts here!!!

[DJSUB]

thanks for the credit on smart guardian skin on the 1st page C-N

i killed another high clocker E8400 C0 on UT P45 T3RS last friday by following the E8600 600fsb overclock settings from the PDF on the DFI site.
i'm just trying to reach 571x7 fsb for my 24/7 settings. i don't know why it happens because i'm only using 1.32vcore on intel stock cooler. my temps on 533x7.5 1.31v on cpuz are only 34c idle with intel stock cooler.

i didn't try to change the pll voltage & my highest vtt is only 1.38v. the only thing i did is changing the clockgen voltage to 3.85v
and do the same cpu gtl / nb gtl & fsb vref from the pdf. when i try to save my settings my system won't boot & i saw the diagnostic led has the 88 code. i shutdown my computer then i open it again after 10 sec. but the led is no display after powering the system.

i tried to clear the cmos but it didn't solve my problem so i decided to put the cpu on my UT P35 & same result happens. no display on diagnostic led & no post. i tried to change the bios chip but the same result.

then i bring my 2 mobos to a friend of mine to test the board, his cpu is working on my 2 mobos but when we tried to test my cpu on his board same result happens no post. i killed another high clocker E8400

that cpu did 626x7fsb on air with Lanparty JR P45.