Are there any tricks to getting this board running with the 1066mhz latch with high FSBs? My ram will run 1270mhz+ with the 5:6 ratio on the 1333mhz strap, but gives me errors when I attempt to drop the strap down to 1066mhz to get the next higher memory ratio. I tried it with a 505mhz FSB and was able to boot, but got memory errors left and right. I've got all of the Clock Gen settings at stock, and have my ram set to +300mv, NB set to +250mv, and FSB set to +175mv. These settings get me a 10 pass Linpak stable setup at PL8, but can't even make it into memtest86+ when dropping down to 1066. I tried bumping the PL up to 10 and even 11, but it didn't help.
--Matt
Edit: I tried setting DDR2 Enhance Mode to Disabled, and tried bumping up the voltage on the ram and the nb. Neither helped.
Reply With Quote
Bookmarks