**Unified** DFI LanParty UT 790FX-M2R-M2RS / Phenom /Data Base Thread**

[Final8ty]

Don't get the ek dfi ut mosfet wb or the nb/sb 5 for the mr2. I just tried ordering them and ended up showing the guys at ek that they don't fit.
If anyone can tell me something else that fits the mosfet and nb then please let me know.

its the additional cpl chips cooler that covers the cpl chips as well (for t2r) without that one (i.e. without cpl chips cooling) its for the m2r. but you can mod the t2r plate to cool the m2r cpl chips as well, but the smaller nb pwm chip would then be left uncovered. the problem is, that the small chip for the nb pwm section is a little higher...

i have the cpl chips aircooled.. works good..

but a good mini file & a Dremel could cure that hight problem.

Water Block for DFI UT and LT motherboads series mosfets.
http://ekwaterblocks.com/shop/produc...roducts_id=322
EK-Mosfet DFI UT - Acetal
Supproted motherboards:
- DFI LANPARTY UT790FX M2R/M2RV
- DFI LANPARTY UT X48 T2R
- DFI LANPARTY LT X48 T2R
- DFI LANPARTY UT X38 T2R DDR2
- DFI LANPARTY UT X38 T3R DDR3
- DFI LANPARTY UT P35 T2R DDR2
- DFI LANPARTY LT P35 T2R DDR2
I cant see any reason why the EK-NB/SB 5 - Acetal will not fit unless there is a resistor in the way on the MR2. as http://shop.anfi-tec.de/ as the same custom blocks that span the intel & the MR2 versions on the SB.

But im going for the anfi-tec anyway as they look like they have put more engineering into the copper base & you apply pressure to the cooper base & not the Delryn top like on the EK.