How to set up GTL Ref Values for 45nm & 65nm

[Cibic]

People, having Loadline Calibration Enabled (or any other vdroop reducer or eliminator) reduces CPU life, CPU needs more voltage and strains system, in my case causes instability in overclocking. Though I had to enable it because I was going over 1.5v.
Full report here http://www.anandtech.com/cpuchipsets...spx?i=3184&p=6

You also mention disabling loadline calibration, would that not also mean having to raise CPU Voltages? Because it's already set to 1.4V in BIOS (1.36V in CPU-Z) and I can't really afford to raise it any higher for 24/7 use :/ (Water cooled but can reach mid 60s under load).

Having a higher voltage on non cpu use will not raise your temperatures, on load though lets say 1.42 LLC Disabled does less heat from 1.42 LLC Enabled.