Quote Originally Posted by safan80 View Post
I never used the nozzle on my dtek v1 and I can tell you... the flow rate is a lot higher on the dtek V1 is a lot higher than the GTZ. my loop design remained the same for the most part. the cyclone is my v1 ek res is pretty weak with the GTZ in the loop by itself compared to the no nozzle V1 dtek with Mcw30 in the loop... any chance I could get you to send me your dtek mounting plate?
I would have been happy to send what I made, but threw it away, and after seeing it you probably would not want it anyways. My temp "homemade bracket" was a 30 minute cut two pieces of thick aluminum strip and drill a few holes and place over the bracket that came with it....see pic.
http://www.xtremesystems.org/forums/...5&postcount=19

And totally agree the Dtek without nozzle had much higher flow than GTZ. In fact the whole reason I bought washer and nozzle for DTEK was not for better temps, it was to slow the flow rate down. I have silent ddc 3.1 pumps, but without enough restriction they make a cavitation sound at high flow rates which is annoying. It sounds like air, but it is not air. But pinch the line enough and slow flow down, sound goes away. All 3 of my identical pumps do that. The GTZ has enough restriction by itself, so no water cavitation sound.