How to set up GTL Ref Values for 45nm & 65nm

[mikeyakame]

I haven't used a P45 yet that wasn't extremely anal when it came to Vtt, it either works great or it throws errors even when its only one step higher or lower. You should be able to enable DRAM static read, and I forget which skew is the lower one, cpu or nb, but for the lower one try around 400ps, higher one try around 100-200ps. Set top one first with other set to normal. Then set top to normal, and setup bottom one, then if you aren't too far off you should be able to set both to the valeus you had working and it should post without hassles. Took me an hour of failed posts to figure out how to set them up fairly quickly.

I remember the values and their relationship to menu, just not the correct skew name I used them for!

Btw very nice memory speeds there! I'm jealous Couldn't find the 9600s here in Australia when i replaced my last set of 4x1GB sticks, so had to settle for the 8800PIs instead. They don't unfortunately have a big working range, most I can get is ~ 1175mhz out of them as pushing more than 2.1v into them just throws errors, but they are rated at 1.9v 1100 5-5-5-15 and the pair I got do rated at 1.82V! I run them at 1148 5-5-5-16 1.96v works good here.

Whats the voltage you need for the 9600s?