Quote Originally Posted by Jor3lBR View Post
Hey CN, any updates or templates close to stable on your setup?

I'm having an annoying MCH Core/Mem Strap errors that where keeping me to test my setup further.

And I know how picky you are on stability so I would greatly appreciate your input.
I posted 4350mhz a few pages back with all my settings which could give you a good start. 4400mhz is all I can call/claim I have got truly stable although 4450~4500 is perfectly stable for everything other than prime/orthos/IBT etc.

I have/did notice something divider/strap dependent I think it was performance level getting set to tight or something like that which stumped me for a minute but other than that I've easily pumped 1.75~1.8v through my NB no problem.

Right now I can get my CPU to run a loop of prime small & then fail large or the other way around depending on how I set up the board for 500 x 9. I am real busy in Jan 09 so wont really get to play with the UD3P until the end of the month & then I think I'll pop the board under my SS & see if that helps.

All in all though the UD3P is an awesome board.