** Official ** Gigabyte UD3 P45 Series -- EP45-UD3 / EP45-UD3R / EP45-UD3P

[Jor3lBR]

Well i'v run 1.6v and its booted fine.

PS I have a TT Toughpower Qfan 750watt .

I will test on a Silverstone 1000W today and settle this strange matter.

Now I also noticed that raisin vcore voltage in ET6 will cause it to reset to default voltage, so I can't even raise any voltages from ET6 anymore.

[Jor3lBR]

I will test on a Silverstone 1000W today and settle this strange matter.

Now I also noticed that raisin vcore voltage in ET6 will cause it to reset to default voltage, so I can't even raise any voltages from ET6 anymore.

Ok heres what I discovered so far:

Dunno how I'm the only one with this issue but I tried the 1000W PSU and same problem happened.

So I played around BIOS and discovered that the combination of RAM Straps and MCH Core causes the issue (no boot or beeps or blank screen).

If I load Original Default and raise MCH Core alone i will hault above 1.440v.

If I change the Ram strap other the the one set on Auto it will work fine.

With other straps the MCH Core can be raised everywhere I want.

Nobody had this? Is that a specific problem with my type of Ram hardware?

[fatguy1992]

Ok heres what I discovered so far:

Dunno how I'm the only one with this issue but I tried the 1000W PSU and same problem happened.

So I played around BIOS and discovered that the combination of RAM Straps and MCH Core causes the issue (no boot or beeps or blank screen).

If I load Original Default and raise MCH Core alone i will hault above 1.440v.

If I change the Ram strap other the the one set on Auto it will work fine.

With other straps the MCH Core can be raised everywhere I want.

Nobody had this? Is that a specific problem with my type of Ram hardware?

I think I may have had that issue to, I can remember a few times when it didn't post and I change the strap and it worked fine .