ASUS Maximus II Formula - new P45 king?

[SkOrPn]

Here is my current attempt at total stability with a simple 4ghz oc. Skews and GTLs are set to auto for now. Below the bios settings I have a screen shot of multiple screen shots showing stability.

Processor:  E8600 E0
Ai Overclock Tuner: Manual
Ratio CMOS Setting: 8
FSB Frequency: 500
CPU Clock Skew: Auto (For now)
NB Clock Skew: Auto (For now)
FSB Strap to North Bridge: 333
DRAM Frequency: DDR2-1002MHz

DRAM CLK Skew on Channel A1: Auto
DRAM CLK Skew on Channel A2: Auto
DRAM CLK Skew on Channel B1: Auto
DRAM CLK Skew on Channel B2: Auto
DRAM Timing Control: Auto (For Now)

DRAM Static Read Control: Disabled
DRAM Read Training: Disabled
MEM. OC Charger: Enabled
Ai Clock Twister: Auto (For now)
Ai Transaction Booster: Manual

Common Performance Level: 10
Pull-in of CHA PH1: Disabled
Pull-in of CHA PH2: Disabled
Pull-in of CHA PH3: Disabled
Pull-in of CHB PH1: Disabled
Pull-in of CHB PH2: Disabled
Pull-in of CHB PH3: Disabled

PCIE Frequency: 100

CPU Voltage: 1.343 (droop unknown)
CPU PLL Voltage: 1.539
FSB Termination Voltage: 1.245
DRAM Voltage: 1.8
North Bridge Voltage: 1.351
South Bridge 1.5 Voltage: 1.54 
South Bridge 1.1 Voltage: 1.12 (For Raid Stability)

CPU GTL Reference (0): Auto
CPU GTL Reference (1): Auto
CPU GTL Reference (2): Auto
CPU GTL Reference (3): Auto
NB GTL Reference: Auto
DDR2 ChA Reference Voltage: Auto
DDR2 ChB Reference Voltage: Auto
North Bridge DDR Reference: Auto

Ratio CMOS Setting: 8
C1E Support: Enabled
Max CPUID Value Limit: Enabled
Intel Virtualization Tech: Enabled
CPU TM Function: Enabled
Execute Disable Bit: Enabled

Load-Line Calibration: Disabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled

I have re-sized the image for 21" monitors so I apologize for blurryness, but I did not like how big the original shot was, lol (on a 24" mon). A friend tells me this is overkill for stability testing but I wanted to make sure. The PC Probe image on the left is Active with LinX running in the background and on the right is a screen of idle. Real Temp shows temps with LinX running after about 10 mins. Real Temp says idle is 44c immediately after the Linx test. I think it normally is around 35c. Not sure if Real Temp 2.90 is accurate or not though.

This OC has been running for nearly two weeks now and has been very enjoyable. Gaming has been ROCK SOLID without so much as a flinch. I quite like how when idle my oc drops to 3ghz, but I had a friend suggest I do that since Im not always at my pc.

At this point I am looking for any tips/pointers as to what I should do next. Should I start with lowering some v? Or is this OC just fine as is? Thanks

SkOrPn