Here are my results sp far fsb wise. CPU not yet testet much. But it doesn't seam to run very well :-/

PLL i had to raise to 1,15 because of boot issues.

You think the MB Volts are fine ?



Bios Settings

PHP Code:

MB Intelligent Tweaker(M.I.T.) 
 
Robust Graphics Booster ..................: Auto
CPU Clock Ratio ..........................: 8 
Fine CPU Clock Ratio......................: +0.0
CPU Frequency ............................: 4.16GHz (500x8.0)
  
Clock Chip Control  
Standard Clock Control  
CPU Host Clock Control....................: Enabled 
CPU Host Frequency (Mhz) .................: 520
PCI Express Frequency (Mhz) ..............: 100 
C.I.A. 2..................................: Disabled  

Advanced Clock Control 
CPU Clock Drive...........................: 800mv  
PCI Express Clock Drive...................: 900mv  
CPU Clock Skew (ps).......................: 0ps  
MCH Clock Skew (ps).......................: 0ps 
 
DRAM Performance Control  
Performance Enhance.......................: Turbo
X.M.P............................................: Disabled
MCH Frequency Latch......................: 333MHz 
System Memory Multiplier ................: 2.00b
Memory Frequency (Mhz) ..................: 1040  
DRAM Timing Selectable ..................: Manual

Standard Timing Control 
CAS Latency Time.........................: 5
tRCD ....................................: 5
tRP......................................: 4 
tRAS.....................................: 15  
Advanced Timing Control [Press Enter]  
tRRD.....................................: 3  [Auto]
tWTR.....................................: 3  [Auto]
tWR......................................: 6  [Auto]
tRFC.....................................: 52 [Auto]
tRTP.....................................: 3  [Auto]
Command Rate (CMD) ......................: 0  [Auto]
Channel A  
Channel A Timings Settings  (all on Auto) 
Static tRead Value......................: 10 (manuell) 

Channel B  
Channel B Timings Settings   (all  on Auto)
Static tRead Value......................: 10 (manuell)
  
Motherboard Voltage Control  

Load-Line Calibration.....................: Enabled
CPU Vcore...............1.25000V..........: 1.387500 
CPU Termination.........1.200V............: 1.260  
CPU PLL.................1.500V............: 1.150
CPU Reference...........0.760V............: Auto (0,76V ET6)
MCH/ICH  
MCH Core................1.100V............: 1.340 
MCH Reference...........0.760V............: 0,698 (0,66  ET6)
MCH/DRAM Reference......0.900V............: Auto 
ICH I/O.................1.500V............: 1,500 
ICH Core................1.100V............: 1,100 
DRAM  
DRAM Voltage............1.800V............: 1,920 
DRAM Termination........0.900V............: Auto 
Channel A Address Vref..0.900V............: Auto 
Channel B Address Vref..0.900V............: Auto 

Advanced Settings  
Limit CPUID Max. to 3.....................: Disabled  
No-Execute Memory Protect.................: Enabled
CPU Enhanced Halt (C1E)...................: Disabled  
C2/C2E State Support......................: Disabled  
x C4/C4E State Support....................: Disabled  
CPU Thermal Monitor 2(TM2) ...............: Disabled 
CPU EIST Function.........................: Disabled  
Virtualization Technology.................: Enabled