**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[areic]

First, your CPU : DRAM ratio is not 67%, that's your GTLREF, which you should leave alone. The ratio is not accessible through uGuru, only in BIOS. You should be able to set your CPU : DRAM ratio to 1:1, the FSB to 400 and not touch anything else, unless you have a C0 chip. Then there is the unlikely possibility that you may need some Vcore. If it's not stable by just adjusting those two, you could try increasing MCH to, say, 1.31v. Shouldn't need it, but it's possible I suppose.

I got to 3.6 by 400Mhz FSB, 1:1 ratio but needed to adjust the MCH to 1.29 (options where 1.29 or 1.33) I then got the BSOD again. So on a whim I upped the VCore to 1.31 and presto, it worked.

Now do I want to decrease one or both of thes until I loose stability, to find the right voltage, or just leave it? My CPU fan has gone up a notch, the temp has always read wrong on this board for me

Thanks a lot man