**Official ABIT IP-35 Pro Review/Overclock/Guide Thread**

[hokiealumnus]

The ram is ddr2 800mhz 4-4-4-12 at 1.9V G-skill Pi

The ratio I believe is 67% I believe, whatever stock is. This is where I am unsure where to go

I mostly OC through Bios but here is a pic of th eAGuru utility

I have got 3.2 and was able to do 3.4 for about 5 min adjusting the mult and the fsb only. I have read that 3.6 should be easy with this chip. My problem I believe is that I dont know haw to adjust the following

CPU GTLREF (both)
VCore
MCH

I honestly just want to get 3.6 and be done with it. The comp is air cooled and I live in Phx AZ so ambient is about 70-80F, so I am not trying to break any records here. Any guidance is appreciated

I wish I was the guy above unable to get above 4.0 haha

First, your CPU : DRAM ratio is not 67%, that's your GTLREF, which you should leave alone. The ratio is not accessible through uGuru, only in BIOS. You should be able to set your CPU : DRAM ratio to 1:1, the FSB to 400 and not touch anything else, unless you have a C0 chip. Then there is the unlikely possibility that you may need some Vcore. If it's not stable by just adjusting those two, you could try increasing MCH to, say, 1.31v. Shouldn't need it, but it's possible I suppose.