x3mgamer The FSB voltage looks a little low I thought 1.20v was the default setting on this board? How's the stabillity?

I'm running my Q9550 2.83GHz @ 3.4GHz

Thanks for all the help guys, I've taken advice from a few different posts and I'm now rock solid stable...

Here's how my system is setup now:

AI Overclock tuner: Manual
CPU Ratio Setting: 8.5
FSB Strap to North Bridge: Auto
FSB Frequency: 400
PCI-E Frequency: 100
DRAM Frequency: DDR2-1060
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: manual

1st Information : 5-5-5-15-5-55-8-5

CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : 5
Row Refresh Cycle Time: 55
Write Recovery Time: 8
Read to Precharge Time: 5

2nd Information : 8-3-5-4-5-4-6

READ to WRITE Delay (S/D): 8
Write to Read Delay (S): 3
WRITE to READ Delay (D): 5
READ to READ Delay (S): 4
READ to READ Delay (D): 5
WRITE to WRITE Delay (S): 4
WRITE to WRITE Delay (D): 6

3rd Information : 14-5-1-6-6

WRITE to PRE Delay: AUTO
READ to PRE Delay: AUTO
PRE to PRE Delay: AUTO
ALL PRE to ACT Delay: AUTO
ALL PRE to REF Delay: AUTO
DRAM Static Read Control: enabled
DRAM Read Training: enabled
MEM. OC Charger: enabled
AI Clock Twister: Moderate
AI Transaction Booster: Manual
common performance level = 8


CPU Voltage: 1.22500v
CPU GTL Voltage Reference (0/2): 0.63x
CPU GTL Voltage Reference (1/3): 0.63x
CPU PLL Voltage: 1.52v
FSB Termination Voltage: 1.24v
DRAM Voltage: 2.02v
NB Voltage: 1.20v
NB GTL Reference: Auto
SBridge Voltage: 1.20v
PCIE SATA Voltage: 1.60v

Load Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : Auto
NB Clock Skew : Auto
CPU Margin Enhancement: Optimized

Advance CPU Settings
CPU Ratio Setting: 8.5
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
Intel® Virtualization Tech: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Enabled