Quote Originally Posted by kaskuli View Post
Those voltages look too raise Cpu voltage >1.3~1.4 PLL>1.5~1.56 NB 1.4~ DRAM 1.96 FSB Termination ~1.36 And perhaps try remove the "Pull-In" settings from Ai Transaction Booster, or even try leave that on Auto... Then take each one down a notch after successful completion of SPI 32 XS 1.5.
ok, I restarted last night after finding my NB needed a fan and I got 450fsb with an hour prime95 blend and 3 passes of mem test in vista ult x64. Everything's aa little high and I want to lower volts/temps as much as possible.

Here are my settings:
Code:
CPU Ratio Setting: 08.0
FSB Frequency: 450
PCIE Frequency: 100
FSB Strap To North Bridge: 400
DRAM Frequency: 1800
DRAM CLK Skew on Channel A1: Auto
DRAM CLK Skew on Channel A2: Auto
DRAM CLK Skew on Channel B1: Auto
DRAM CLK Skew on Channel B2: Auto
   1st Information 8-8-8-24-5-88-10-5
DRAM Timing Control: Manual
CAS Latency: 8
DRAM RAS to CAS Delay: 8
DRAM RAS Precharge: 8
DRAM RAS Activate to Precharge: 24
RAS TO RAS Delay: Auto
Row Refresh Cycle Time: Auto
Write Recovery Time: Auto
Read To Precharge Time: Auto
   2nd Information 8-5-9-4-9-4-8 all on Auto
   3rd Information 22-7-1-9-9 all on Auto
DRAM Static Read Control: Auto
DRAM Dynamic Write Control: Auto
DRAM Read Training: Auto
DRAM Write Training: Auto
MEM OC Charger: Auto
Ai Clock Twister: Auto
AI Transaction Booster: Manual
   C/P : A1 A2 |  B1 B2
   LVL : 11 11  | 11 11
Common Performance Level: 11
All Pull-ins: Enabled

CPU Voltage: 1.37500
CPU GTL Voltage Reference (0/2): Auto
CPU GTL Voltage Reference (1/3): Auto
CPU PLL Voltage: 1.56
FSB Termination Voltage: 1.30
DRAM Voltage: 1.90
NB Voltage: 1.40
NB GTL Voltage: Auto
SB Voltage: Auto
PCIE SATA Voltage: Auto
Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew: Auto
NB Clock Skew: Auto
CPU Margin Enhancement: Optimized
I still need more testing, but I'd like to get the vcore lower and temps down. Max temp is like 73C with HWMonitor 1.12, NB is around 52C load using DDM and I'm sure it's at least a few degrees higher than that reading.

-=Mark=-