DFI Lanparty UT P45-T2RS Banter starts here!!!

[Jor3lBR]

Mine came in today. Installed board and it wouldnt post. power supply just beeped over and over.
Then i remembered, a few years ago i had a DFI 680i that did the same thing with this power supply.
Apparently early revision Enermax Power supplies do not work correctly with DFI Motherboards.
Google confirmed this. I was able to get it to occasionally post by removing the floppy PCIE power connectors,
per DFI forums. Now it posts 60% of the time.

So far i havent been able to get this quad to boot higher then 450fsb. This bios is so intimidating.
Sooo many different or different named adjustments, I dont really know where to start.
I started with C-Ns dual core template as a baseline and modified and adjusted from there.
Not much luck. I wish there were some more Quad users with this board to cheat off of
Some high FSB ABS files would be awesome. I'll keep playing with it for a few days till my UD3P gets here,
Maybe i'll have some luck by then.
Which thread could i read to get me more knowledgeable with these bios settings, Does the x48, p35 or others have the same settings?
I'll check em out and see.

That's pretty bad new for me.

Those you pointed have close BIOS try to peak on the X48 Thread.

Keep GTL Ref Settings around 67% VTT for the Q9650. Also don't be shy on NB volts.

See if RGones Template help you with the Quad:
http://csd.dficlub.org/forum/showpos...2&postcount=14

If you can make 8x500 pretty sure you'll get too 9x500 or more...