Forgot to mention I loaded up the 1028 BIOS the other day & couldn't tell any difference from 1007.

I also had a play with 4 X 1GB sticks of ram & the board loved them, I could hardly tell the difference between 2GB & 4GB!!!

600+ fsb was just as easy with 4 x 1GB sticks



I also ran an hour of prime using 4096k with the same settings as my overclock I already posted in this thread.



The only changes to my previously posted OC are as follows. (Note lower VDIMM & VNB Needed thanks to tweaking the skew's.

Code:
>Clock Setting Fine Delay Press Enter:

DLL And RCOMP Settings.............. - Auto
Ch1 Dram Defaul Skew................ - Model 2
Ch2 Dram Defaul Skew................ - Model 2

>Voltage Settings:

DRAM Voltage Control................ - 2.17v
NB Core Voltage..................... - 1.322v

>DRAM Timing:

Performance Level.................... - 8

>Read delay phase adjust Press Enter:

Channel 1 Phase 0 Pull-In........... - Enabled
Channel 1 Phase 1 Pull-In........... - Enabled
Channel 1 Phase 2 Pull-In........... - Enabled
Channel 1 Phase 3 Pull-In........... - Enabled
Channel 1 Phase 4 Pull-In........... - Enabled

Channel 2 Phase 0 Pull-In........... - Auto
Channel 2 Phase 1 Pull-In........... - Auto
Channel 2 Phase 2 Pull-In........... - Auto
Channel 2 Phase 3 Pull-In........... - Auto
Channel 2 Phase 4 Pull-In........... - Auto