Quote Originally Posted by largon View Post
HitandRun,
OCP: find a surface mount resistor connected to pin#35, measure resistance across the resistor (basically between pin#35 and ground). Solder a VR rated ~20 times the measured value across the resistor. Lower resistance to push back OCP trigger point.

About OVP (as per PM)....
Does the card crash if you increase voltage without any load on the GPU?
Sorry for the late response, very busy at work! Largon Pin # 35 to ground is 6.47kOhm. Regards to OVP. Card shuts off in idle when more than 1.5V is applied.

Quote Originally Posted by Bellisimo View Post
hmm, think i have found the ocp resistor and the ovp resistor
possible the ocp resistor is 8kohm and the ovp resistor is 130k ohm?

fount the mem controller i think: APW7065

http://www.anpec.htm.tw/ashx_prod_fi...me=APW7065.pdf
Nice! What memory do you have on this card?