Quote Originally Posted by Leeghoofd View Post
STOP USING AUTO PLZ FOR THE FOLLOWING SETTINGS !!! UNLESS YOU HAVE VERIFIED WITH A DIGITAL MULTIMETER THAT YOUR BOARD DOES NOT OVERVOLT LIKE MOST E AND DLX BOARDS....
CPU PLL Voltage: Auto --> Try 1.26
FSB Termination Voltage: Auto --> TRY 1.22

and try to go lower on them... though do NOT use the lowest settings possible

CPU PLL Voltage: 1.5 THESE OVERVOLT AS MUCH AS AUTO
FSB Termination Voltage: 1.1 THESE OVERVOLT AS MUCH AS AUTO
so which numbers to use then? 1.26/1.22 or 1.5/1.1 ( I assume the former)

also, looking at some of the previous posters in the past 3 pages, there has been a lot of people with CPU PLL Voltage > 1.5v....should I not approach this?