ASUS Maximus II Formula - new P45 king?

[psygnosi]

Hi Cryptik,

I have these settings currently on my system and IBT gets 10 passes and prime95quad passes for 12 Hours. I need help tweaking the GTLs. I'm not sure I if I did the calculations correctly. Thanks in advance.

Psygnosi

4.0Ghz (8.5 x 470)
Processor: Q9550 E0 FPO/Batch L827A932 S-Spec SLB8V

Extreme Tweaker
Ai Overclock Tuner : Manual
OC From CPU Level Up : Auto
CPU Ratio Control : Manual
- Ratio CMOS Setting : 8.5
FSB Frequency : 470
CPU Clock Skew : Auto
North Bridge Clock Skew : Auto
FSB Strap to North Bridge : Auto
DRAM Frequency: DDR2-940MHz
Dram Clock Skew CH1 A1 : Auto
DRAM Clock Skew CH1 A2 : Auto
Dram Clock Skew CH1 B1 : Auto
Dram Clock Skew CH1 B2 : Auto


DRAM Timing Control: Manual
CAS# Latency : 5
RAS# to CAS# Delay : 5
RAS# Precharge : 5
RAS# ActivateTime : 15
RAS# to RAS# Delay : Auto
Row Refresh Cycle Time : Auto
Write Recovery Time : Auto
Read to Precharge Time : Auto

Read to Write Delay (S/D) : Auto
Write to Read Delay (S) : Auto
Write to Read Delay (D) : Auto
Read to Read Delay (S) : Auto
Read to Read Delay (D) : Auto
Write to Write Delay (S) : Auto
Write to Write Delay (D) : Auto

Write to PRE Delay : Auto
Read to PRE Delay : Auto
PRE to PRE Delay : Auto
ALL PRE to ACT Delay : Auto
ALL PRE to REF Delay : Auto

DRAM Static Read Control: Disabled
Dram Read Training : Disabled
MEM OC Charger : Enabled
Ai Clock Twister : Auto
Transaction Booster : Manual

Common Performance Level [10]

Pull-In of CHA PH1 Enabled
Pull-In of CHA PH2 Enabled
Pull-In of CHA PH3 Enabled
Pull-In of CHA PH4 Enabled
Pull-In of CHA PH5 Enabled
Pull-In of CHB PH1 Enabled
Pull-In of CHB PH2 Enabled
Pull-In of CHB PH3 Enabled
Pull-In of CHB PH4 Enabled
Pull-In of CHB PH5 Enabled

PCIE Frequency : 100

CPU Voltage : 1.39
CPU PLL Voltage : 1.56
FSBT : 1.25
DRAM Voltage : 1.9
North Bridge Voltage : 1.25
South Bridge Voltage 1.5 : 1.5
South Bridge Voltage 1.1 : 1.10

CPU GTL Reference 0 : Auto
CPU GTL Reference 1 : -40mv
CPU GTL Reference 2 : Auto
CPU GTL Reference 3 : -40mv
North Bridge GTL Reference : Auto
DDR2 Channel A REF Voltage : Auto
DDR2 Channel B REF Voltage : Auto
North Bridge DDR Reference : Auto

Load Line Calibration : Enabled
CPU Spread Spectrum : Disabled
PCIE Spread Spectrum : Disabled