I really wonder whether they tested this board before release!!

- I have RAID Problems at set-up but I found what my problem was. I raided 0 three Samsung F1s and I made to partitions one 150GB and one huge 2.8GB (the rest). Unless I delete the second big partition windows will not recognize my RAID array at during setup.

- I really trying to set it up with OCZ PC3 Platinum 12800 - (AVOID THIS RAM with this board).

-For a strange reason the board fails to turn on many times and I have to turn off my PSU (Thermaltake 1200Watt) on and off many times. Grrrrrrrrrrrr this is ridiculous.


I finally corrupted my Vista installation and I can't even repair unless I delete the second partition. So I am using a forth TB disk to install Vista there again, move the data from the big partition (the 2.8GB) that causes recognition failure at set up then boot from cd and repair the original installation. After that I will disconnect my RAID disks and experiment with the single disk installation after I make an image from it.