ASUS Maximus II Formula - new P45 king?

[Grnfinger]

Ok well for 445 FSB PL8 on the 266 strap I run my vNB at 1.27225v, NB GTL Ref on auto. However because you have a quad obviously you'll need more voltage for stability. I know you know what you're doing but what have you tried to regain stability other than down clocking to 3.9GHz?

I have had similar instability over the past few days, and actually needed to increase my GTL's a little to regain stability.

I have upped VTT PLL GTL's same damn thing core 4 fails at the 1 hour 19-22 min mark in prime BUT will pass 10 loops of linpak but run it twice and it fails 1out of 10 loops
I suppose it could be burn in, ran the chip hard since it was new just didnt want to up vCore any more.

Could it be degrading, No offense but i have seen few of your bios setting page and some volts are pretty high for 45nm

This is not Grandma's house if your affraid to push you chip then I think your in the wrong forum

And you really think I post my final settings?