I'm about to set up a fresh install on this board today.

My question is please, to those who set up a raid 0 config,

I know for XP you need to press F6 and load the raid driver as usual. For Vista 64, do I need to load a raid driver or is the ICH10R one already on the vista cd? I know for my 680i and 750i nvidia boards that use the ICH9R that there is no need to load it for Vista. I'm just not sure if Vista has the ICH10R. Thanks.

Also on the Gigabye driver page for the UD3R, under SATA RAID section there are three downloads listed. What's the deal with the 25mb package? Does it have all of the drivers together? Then below it there are the two .28mb and .30mb 32 and 64 bit drivers. This is very confusing how they organize their downloads? Which do I use for a RAID 0 XP 64 and vista 64?

Thanks.