Quote Originally Posted by vox View Post
Hello Amurtigress!


P5Q3 Dlx
Q9550 C1
Ram GSkill 2x 2GB DDR3 1600 CL7 1.9v
HX 1000wts

Sory for the no specs! here they are updated:

Overclocker Tuner: Manual
CPU Ratio Setting: 8.5
FSB Frequency: 485
PCIE Frequency: 100
FSB Strap To North Bridge: Auto
DRAM Frequency: ddr3-1459
DRAM CLK Skew on Channel A1: Auto
DRAM CLK Skew on Channel A2: Auto
DRAM CLK Skew on Channel B1: Auto
DRAM CLK Skew on Channel B2: Auto
DRAM Timing Control: Manual

CAS Latency: 7
DRAM RAS to CAS Delay: 7
DRAM RAS Precharge: 7
DRAM RAS Activate to Precharge: 18
RAS TO RAS Delay: Auto
Row Refresh Cycle Time: AUTO
Write Recovery Time: Auto
Read To Precharge Time: Auto
DRAM Static Read Control: Disabled
DRAM Dynamic Write Control: Disabled
DRAM Read Training: Disabled
DRAM Write Training: Disabled
MEM OC Charger: ENABLE
Ai Clock Twister: auto
AI Transaction Booster: AUTO

CPU Voltage: 1.40
CPU GTL Voltage Reference (0/2): 0.620
CPU GTL Voltage Reference (1/3): 0.620
CPU PLL Voltage: 1.60
FSB Termination Voltage: 1.46
DRAM Voltage: 2.00
NB Voltage: 1.40
NB GTL Voltage: 0.620
SB Voltage: 1.10
PCIE SATA Voltage: 1.50
Load-Line Calibration: Enabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew: AUTO
NB Clock Skew: AUTO

I have bios 1406 can boot and run Orthos for 10mts.

Just for bench i can make 8.5x500!!!

What adjustments do think i can make here?

tks
vox
the ones I mentioned before. those values you had there are seriously wrong, to my experiences.

tRRD refers to RAS to RAS delay (Set to 8-10, AUTO sets it to 5!), and trfc to 82-88.

And limit the FSB to approximately 460 for now until you get stable. The P5Q3s seem to hit a FSB wall at roughly 470.