1st attempt @ WC rev1.0 Warning lots of pics

[Detale]

Great work so far, has my first loop beaten by a mile

What kibbler is talking about is Galvanic corrosion. If an ALu fillort is submersed in a copper loop it will corrode like crazy. If it is not in contact all the time you ar A-OK

Again, great work. Only advice I can give is take your time.

Thanks man a huge compliment coming from you. I am trying to be patient but it's so damn hard
* goes to Google "Galvanic corrosion"....Uh Oh well looks like I am going to have to change the drain port then. Any recommendations anyone?

That's an amazing first setup. Looking very nice. One comment, I can't tell the direction of flow but make sure the water flowing into your cpu block goes into the lower left barb in your cpu block. The one with the dot right above it. Just a thought, but it might help.

Wow you know. I think I read that somewhere that there is a directional flow on the waterblocks right? Crap I just put the hoses where I thought they would work out better. I'm going to check it out and all will be fixed come rev 2. Which should be this coming week depending on Bitspower RMA's

Edit: I looked it up and per Swiftech's specifications you are right

The housing is CNC machined out of durable Delrin material, and designed for impingement cooling over the CPU hottest area. The flow path, as illustrated below shows that the Apogee™ GTZ is port specific: inlet and outlet cannot be interchanged.

Thanks for that I have it backwards ATM I will switch it when I drain the water and refill. I knew I came to the right place