Hey guys, again ; )
I think I'm getting addicted to tweaking/oc'ing. I've been looking around for some advice on tweaking the performance level, but I'm a little confused.

-Should I leave my settings as it is? Or would it make a difference to lower PL and disable All Pull-ins? I want to stay at 3.6ghz for now, just trying to optimized at this point.


Code:
e8400/2x2gb gskill ddr2-800

AI Overclock tuner: MANUAL
CPU Ratio Setting: AUTO
FSB Frequency: 400
FSB Strap to North Bridge: AUTO
PCI-E Frequency: 100
DRAM Frequency: 801
DRAM Timing Control: MANUAL (5-5-5-15)

DRAM Static Read Control: ENABLED
DRAM Read Training: AUTO
MEM. OC Charger: AUTO
AI Clock Twister: AUTO
AI Transaction Booster: MANUAL 
Performance Level : 11 
ALL PULL-INS ENABLED

CPU Voltage: 1.25625 (1.24v CPUz)
CPU GTL Voltage Reference: AUTO
CPU PLL Voltage: 1.52
FSB Termination Voltage: 1.26
DRAM Voltage: 1.90
NB Voltage: 1.26
NB GTL Reference: AUTO
SB Voltage: AUTO
PCIE SATA Voltage: AUTO

Load Line Calibration: ENABLED
CPU Spread Spectrum: DISABLED
PCIE Spread Spectrum: DISABLED
CPU Clock Skew : AUTO
NB Clock Skew : AUTO
CPU Margin Enhancement: OPTIMIZED

C1E Suppport: ENABLED
Max CPUID Value Limit: DISABLED
Intel Virtualization Tech: DISABLED
CPU TM Function: ENABLED
Execute Disable Bit: ENABLED
Intel Speedsteb: DISABLED
Intel C-state: DISABLED