Need Multi-GPU Help......56K!

[Naja002]

Wait....

I think the flags only work on the console versions when put in the command line. Try this! Remove -gpu 0 and -gpu 1 from the command line, then put them in the client parameters instead. Can't hurt to try, can it?

Ok, that just put me back to the same place as doing it via the shortcut properties:



I had to go into the files to the config file via notepad and remove the -gpu 1 in order to get back to where I was.....

Did you tell windows to extend the desktop to include a monitor for each GPU? This seems to be required at least for me under xp32. Not sure about your OS.

Yes, I tried that, but its not taking it, or wasn't (I may try it again). It shows 4 monitors, but 3 are inactive. It doesn't matter which one I try to extend it to--it just won't do it. My OS is Vista 64.


Its working on 2 different WUs, so either 1 gpu is working on both WUs (not likely I don't think), or each gpu is working on its own WU, but at half the rate. I'm working if this is a bandwidth issue somehow. I didn't see anything in the Bios.....any thoughts?


EDIT: Just tried it again--No Go. It will jump through the hoops, but ends up right back to the extend checkmark not there. Tried all 3 "inactive" monitors again.