"ASUS P5Q Deluxe discussion".

[Tulû]

The 0.63 and 0.67 are the most common settings for the Q6600's, but not written in stone, but are the most common used and i suggest putting them to that.. basically use my template settings and try all of them out and you may get stable, but your VID is a higher VID then mine and you may have to go even higher voltage then what i am using and that causes a HEAT issue, you maybe one of those who has to settle for 3.4ghz @ 1.42v or 1.43v or 1.44v or 1.45v.

Look at my voltage = 1.43 full load and in Bios 1201 it is 1.425 .... so try it out... is all . keep an eye on your temps ... under 70C is fine .. 60-63C is average on air cooling for CORE 0 full load.

Update BIOS to 1201 and try settings as no one here can absolutely state 100% what you should run at, but my settings have helped many as they had to adjust this or that for themselves to get stable, but at least they have a very good reference point from my template.

You may have to settle like i stated with 3.4ghz and also maybe memory @ 901mhz to 1080mhz.

Also one note .... CLOCK MASTERS .. dude i ain't no newbie when it comes to overclocking componets either and i like to state everyone has things to suggest or use as every componet can be and maybe different from others.

Another NOTE my ram is rated at 2.0-2.1v at 1000mhz i am running @ 901mhz, but if i run it at 2.0v i would error out, so i dropped to 1.96 and i pass whatever can be thrown at it now.

Hey there .
Thanks again for advice ; but i still think i have a cpu issue not ram .
"clock masters" , don't take it personal please , you missunderstood me i think . I know that everybody here knows something better than me.
I 'll try a one notch higher Vcore . Will disable Dram static read and mem oc. charger .
Btw , my temps were max 68 68 62 62 at prime blend for 6 hours and my room is abaout 30C.
Are these temps normal ?
Thank you very much .