Quote Originally Posted by SuporterPoli View Post
@RunawayPrisoner: sorry to name you again, but do know i dont have anything against you, just really want to clarify some info.
Is there any possibility that Intel made the table that you are mentioning(2.3) for 2664MHz and the other one(2.2) for as a general information?
So basically 1.1vtt is enough for 8x333.
I'm currently running 1.347vcore(idle) and 1.332vtt(idle) for 3.55GHz in my Q9450 and after what you are saying i'm slowly/quickly killing my cpu. But my temps never go higher than 60degrees with a TRUE w Scythe S-Flex 1600rpm fans in push-pull. I'm tempted to go as high as 1.375 with the vcore and 1.35 with the vtt so see if i can reach 3.6.
I saw people shoving more than 1.4volts vcore in their duals. Also the anandtech dudes put their vtt at 1.45 which is pretty much near the absolute maximum rating, if not over when their board overvolts.
Ehh... I need only 1.10v for VTT even at 3.8GHz, The only thing I need to increase is my NB voltage to reach higher clocks.

Quote Originally Posted by truehighroller View Post
No I mean it it overvolts bad, you should bump the settings "voltages" one step up otherwise you are pumping like 1.58v through the nb for example. Yes it does it that bad. The more I think about it maybe my was overvolting my nb to 1.58v or something and that was ing it up..... Anyway I just noticed you were at the lowest voltages and I remembered that it is bad on this board "real bad". Thanks again I just woke up and I am going to do some swapping of stuff here and see what I get.
If it pumped that much through the NB, I'd think it would have died a while ago, because that area is always 60C, and with the NB overvolted so much, it would overheat. Seeing as to how a 24-hour prime sesson was possible, I guess it did not overvolt at all.

Edit: And yeap... just as I suspected. The board got stumped or something. If you are stable, even at stock, on a P35, then I guess that chip is too fine.