"ASUS P5Q Deluxe discussion".

[TI66ER]

Here they are,thanks guys

fsb---------------------------400
FSB Strap to North Bridge:----400
PCI-E Frequency:--------------101
Dram Freq--------------------1066
Dram timing control--------manual
cas latency---------------------5
dram ras to cas delay-----------5
dram ras precharge--------------5
dram ras activate--------------16
ras to ras delay-------------auto
row refresh cycle time-------auto
read to precharge time-------auto
---------------------------------
read to write delay----------auto
write to read delay----------auto
write to read delay(s)-------auto
write to read delay(d)-------auto
read to read delay(s)--------auto
read to read delay(d)--------auto
write to write delay(s)------auto
write to write delay(s)------auto
write to write delay(d)------auto
---------------------------------
write to pre delay-----------auto
read to pre delay------------auto
pre to pre delay-------------auto
all pre to act delay---------auto
--------------------------------
DRAM Static Read Control:disabled
DRAM Read Training:----------Auto
MEM. OC Charger:-------------Auto
AI Clock Twister:------------Auto
AI Transaction Booster:------auto
---------------------------------
CPU Voltage:--------------1.4250V
All CPU GTL Voltage Reference:Auto
CPU PLL Voltage:-------------auto
FSB Termination Voltage:-----1.3v
DRAM Voltage:----------------2.2v
NB Voltage:-----------------1.20v
NB GTL Reference:------------Auto
SBridge Voltage:------------1.10v
PCIE SATA Voltage:-----------auto

Load Line Calibration:------disabled
CPU Spread Spectrum:-----Disabled
PCIE Spread Spectrum:----Disabled
CPU Clock Skew:--------------auto
NB Clock Skew:---------------auto

Advanced CPU Settings: All Disabled except execute bit disable

I had these-
MEM. OC Charger:-------------Auto
AI Clock Twister:------------Auto
AI Transaction Booster:------auto

on their lowest settings,then i put them on auto and ran memtst,it passed 1 full test and i got 1 error on test 4 on the second pass.The ram is a few weeks old,that i got back from an rma.I have not ran it higher than 1066/2.2v since i got it back.It is pc8500 single sided tracers-BL12864AL1065.8FE5

Before i put them settings on auto,i ran mem test and it had loads of errors straight away nearly.