"ASUS P5Q Deluxe discussion".

[Leeghoofd]

Try these settings Ricochet, plz change one value at a time plz some boards are picky with voltages... so you have an idea where it goes wrong if it didn't post

First off I've seen many run closer to 1.4 on a 45nm esp on the P45's because they're a dye of the P35 or something right?

Here's my setup (I tried to have it as my sig)

MOBO: P5Q DLX P45
CPU: E8400 Wolfdale w/ Thermalright 120eX
RAM: 4GB Corsair Dominator PC8500
GPU: 8800GTS (G92) <-- soon to be 4870X2

Try these :

JumperFree Configuration Settings
AI Overclock tuner: MANUAL
CPU Ratio Setting: set 8x first then 9X
FSB Strap to North Bridge: AUTO
FSB Frequency: 450
PCI-E Frequency: 101
DRAM Frequency: 1081
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: AUTO

1st Information :

CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 18
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: 55
Write Recovery Time: AUTO
Read to Precharge Time: AUTO


DRAM Static Read Control: Disabled
DRAM Read Training: AUTO
MEM. OC Charger: AUTO
AI Clock Twister: AUTO
AI Transaction Booster: AUTO

CPU Voltage: 1.35 --> depending on ya CPU ofcourse
CPU GTL Voltage Reference (0/2): AUTO
CPU GTL Voltage Reference (1/3): AUTO
CPU PLL Voltage: 1.6 --> set first at AUTO then this value, try to find the lowest possible plz
FSB Termination Voltage: 1.32 --> set first at AUTO then this value, try to find the lowest possible plz
DRAM Voltage: 2.1
NB Voltage: 1.26 --> set first at AUTO then this value, try to find the lowest possible plz
NB GTL Reference: AUTO
SBridge Voltage: AUTO
PCIE SATA Voltage: AUTO

Load Line Calibration: Disabled
CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled
CPU Clock Skew : AUTO
NB Clock Skew : AUTO

Advance CPU Settings
CPU Ratio Setting: Manual
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
Intel&#174; Virtualization Tech: Disabled
Vanderpool Technology: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled

I am having 3dmark cpu score problems I'm only scoring about 5200-5300 with my Q6600 at 3.7ghz. I should be getting 300-500 pts more than that... I tried dropping my multi and upping the FSB from 412x9 to 463x8 but I only get like 10-20pts more :/ I have 4x1gb ocz at 1100mhz 5,5,5,15 PL 9 and running bios 803 beta

Anyone have any ideas? normally I wouldn't be so picky but I am only a few hundred pts away from taking the 1st single card score on another forum and it's my CPU score that's holding me back.

9 x 425 then gave me 6000 points in CPU score (not on P45 though) will try tonite to see if I can get at it again with the Qx