ASUS P5E64 WS Evolution - Tips, Tricks, Mods, BIOS, OCing & More...

[StimulatedBoy]

I'm about to get a headache here in the Banana Republic... After 24 hours of testing and system found stabile, I am suddenly getting BSOD's all over the place. I even managed to play BF2 for 6 hours with new RAM at 1760 (8-7-7-20) and with CLK Skew set to 50 Advanced settings and today it is a no go... Board won’t even boot at 8-8-7-24 so I have had to back down to 8-8-8-24 (which is standard for this RAM at 1.8V).

CLK Skew that was set to 50 advanced is again set to AUTO
CPU PLL Voltage is set to 1.66
FSB Termination Voltage set to 1.34
DRAM Voltage set to 1.9
The rest of the voltage settings are now set to AUTO.
Load-Line Calibration is still giving me BSOD’s no matter what when set to Performance, so set to Normal...

@Holmer, you can probably raise the CPU PLL Voltage to 1.7 for higher stability. RAM is based on Samsung (http://www.samsung.com/global/busine...m=M391B5673DZ1). This link for our RAM will probably help you out a little bit although I am not even close to achieve their results... (http://www.xtremesystems.org/forums/...d.php?t=187853).