using car radiators...why not?

[Naja002]

Ok, I'm getting in on this deal:

I just bought this:

80-85 SKYLARK, CITATION w/ HDC NEW RADIATOR--3 rows, copper/brass--$88.50 shipped

Lots of Copper/Brass radiators at Great prices--some damaged, some not--check the description:

ltiparts

And 2 of these:

PROCOMP 14 INCH ELECTRIC COOLING FAN 14" CURVED BLADE

They have 10, 12, 14 and 16" fans--cheapest prices I could find shipped--$55.80 shipped for 2. 2150cfm @ 12v and 12 amps. I'll worry about the amps, draw, undervolting later.....


I've been looking for a project. I was ready to do the copper pipe in the crawlspace and tossing around different things. I bought a mag drive 9.5 (950gph, 14' head, $60 shipped) and I have a 55gal. blue barrel. I started the plumbing yesterday. Just picked up another MB and so now I'll have 3 PCs to crunch and I'll continue my everyday stuff on one of those as I do now.

Plumbing is going to the outside. From the PCs to the blue barrel to the car rad and then back again to the manifold. The car rad is either going into 1 of 2 crawlspaces or an out-building that's shaded all day (probably the out-building.) I have a Swifty 120.2 and 2 '77 Bonneville heater cores to incorporate--if needed in any way. However, I will just do a manifold that feeds to and from each PC. Each PC will receive it own feed, so life should be good!

Yes, I'm excited.


Let's...


</Hijack>

Sweet setup, Alex. Looking forward to watching this thread......