Gigabyte MA790FX DQ6

[G0ldBr1ck]

-= rtz =- : I had forgoton about that isue with the bios. It was the same for me but was no big deal to leave it on auto as it was still setting it correctly to the EPP. It looks like yours is too, so realy not a problem unless your wanting to go tighter then EPP timings.

EDIT: Sorry Just now noticed your at 533 DDR. Was that all that you could Get to boot?
Have you tried leaving dram speed on auto and timings on auto and turned on EPP in Xpress, then check with AOD? With my X2 that would set my Ram to ddr800 with correct EPP timings and then I clocked the ram up to 1066 with the HT bus.

[-= rtz =-]

G0ldBr1ck: ATM im running 330x10 with ram on 1100 MHz/667 in bios w auto settings...HTT is on 1300 MHz Not tested stable yet xcept a quick 3dmark 06 run which passed.
Is there a danger of running a high htt link? I saw this board did 2000 with an X2 (Lightman).

I cannot enable EPP in xpress via bios,its disabled/greyed out.I think I will just reflash to F2 or even F1 if F2 reflash will be possible without killing the board