BenchZowner - Thank you very much for your thoughts on my question, much appreciated! With that said your settings are very impressive to say the least man, those timings are super tight! Plus it looks like you have been able to actually boot into Windows with those settings (as in you didn't have to use MemSet to tighten everything up once you were actually in Windows), is that true or did you have to use Windows based programs to tighten stuff up a bit? Last but not least in the first two of your three screenshots you were running at 510FSB x 9.0 = 4.6Ghz, well what voltages were you running with those settings, do you remember?

vcore:
PLL:
VTT:
vdimm:
SB:
NB:
*Did you mess with any of the GTL's (either CPU GTL's or NB GTL's) for any of your recent bench sessions? Thanks man! Oh crap, given your vast experience with serious clocking on this board have you found any of the voltage read points on the board yet (besides the VDIMM and CPU points on the bottom of the PCB (or the VDIMM point on the top of board between the right-most DDR3 slot of the ATX connector)? Most importantly I'm curious about the actual VTT voltage read point? Thanks again man!

PMP - Your help is greatly appreciated, especially in regards to your BIOS release information! Otherwise we might not have had any information on the change log for these files! Now this may be a stupid question but, when a new BIOS file is released does it usually contain all the previous fixes/changes from old BIOS files along with any new fixes/changes? I suppose that this depends on which BIOS file the new release was built off of?