Back from the meeting.

Thanks for comments!

I like the the look of that board, I've been twitching about what I should buy next, that would help out with not having to strip my current build down to get this finished. I've never used a DFI before 'maybe time to try now'

TBH I haven't looked at the front door fitting, its currently shoved up in the beams of the garage as I tended to get p'd off with having to open it so took it off.

I'll see if it fits and then see what I can do with it, if it does as I've fitted 2x 80mm fans behind the front grill to help cool the HDDs, as it tends to get too warm there otherwise (design fault IMO)

I toyed with doing either orange drive bays with black handles, or the way it ended up, I think I made the right choice, as I don't want it to be too OTT.

I've got a windowed side panel on pre-order £28 (not bad) saves a lot of work.Plan to paint that black.

I'll take the front off tomorrow and post some pics of the fans.

Just started playing with rad mounting.

Theres a twin and triple rad ready ATM, but might get a PA160 and just use that with the double rad so I can keep everything inside the case.

Still got to work out what goes on which water loop, as will be 2 inside.