**Official DFI LanParty UT 790FX-M2R Review/Overclock/Guide Thread**

[justapost]

Had a disc failure so i had to reinstall on a single hd today.

Install log:
2.9/2.4GHZ 1.4/1.35V failed
2.9/2.4GHz 1.425/1.375V failed
2.9/2.2GHz 1.4/1.35V failed
2.9/2.2GHz 1.4125/1.3625 failed
2.8/2.2GHz 1.4/1.35V in progress / EDIT: worked

Always getting blue screens during installation. Sometimes IRQ related sometimes page faults sometimes without comments.

Edit3: @3000 CPU-FID=15 All default ( I changed both CPU Multi, Genius main page and CPU config CPU-FID, when in Windows had only 12.5 as Multi. )

I can not set the CPU-FID if i set the cpu multi on the genius main page here.
Can you boot 3GHz at stock (1.3V) voltage?
And to nag you albit more, have you checked the max ref Ht you can get? Mine tops out at ~270MHz where the 9600BE did up to 285MHz. (on 3-07 bios).
Also I found the higher the ref HT the lower the possible max nb frequency can be.

@Gunther: Nice polish, how much did you remove?