Quote Originally Posted by dogin View Post
Yeah the EnZotech SLF-1 from chilled PC and it comes with the low profile fan. Cut off the outer end of the attachment points and then routed out the inner attachment hole so they lined up with the mobo holes. Squeezed the two ends closer together that were left after cutting the outer portion off. Also used thermal glue even though it looked like the pins were doing there job. Looks like I got a tight fit with EnZotech. Flushing the rad now so hopefully get the leak testing done this weekend (just need some free time).

Really like your set-up zlojack. Hope mine goes uneventful like yours with no leaks and the mobo still works???
Well so far I have one really small leak (like about 1 drop every 2 hours) from the interior rad's intake. I've tried to tighten the fitting and now I'm checking again.

I haven't powered back on yet...still leak testing. I didn't get a fan with my Enzotech, but I'm not sure if the SB needs it. My case also has a huge 25 CM side fan which will blow over the whole mobo (TT Armor).